Help
Search

Add touchpoints

Add a feedback terminal, feedback link, review site, website widget or Tasks to a location.

Checked against the app: , Yump 5.0.03 min read
Before you begin

A touchpoint is what collects feedback or runs tasks at a location. Each touchpoint needs a subscription ID from Yump.

There are two ways to add one: the Touchpoints tab in Admin, or the location's own settings.

Add a touchpoint in Admin

A touchpoint you add here is saved at once.

  1. Go to Admin in the sidebar and open the Touchpoints tab.
  2. Pick a location or a website. With a folder picked, Add touchpoint is off and says "Pick a location to add a touchpoint."
  3. Click Add touchpoint. For a location, choose Feedback terminal, Feedback link or Tasks. For a website, choose Website widget.
  4. Under Subscription ID, enter the subscription ID from Yump.
  5. Under Name, give the touchpoint a name.
  6. Click Add.

A location can have one feedback link and one Tasks. If it already has one, the menu item is off and says "This location already has one."

Review sites are not in this menu. Add them in the location's or website's settings (see below).

Add a touchpoint in the location settings

  1. In Admin, open the location's menu and choose Edit location. For a website, choose Edit website.
  2. Go to the Touchpoints step.
  3. Click Add touchpoint. For a location, choose Feedback terminal, Feedback link or Review site. For a website, choose Website widget or Review site.
  4. Fill in the dialog and click Add.
  5. Click Save. Nothing is saved until you do.

If the location already has a feedback link, Feedback link says "Already added". With no touchpoints yet, the step says "No touchpoints yet" and "To add one, you need the subscription ID from Yump."

The subscription ID sets the type

You do not pick the device yourself. Yump reads the subscription ID and sets the type. For example, a Feedback terminal becomes an ExpressPod or an ExpressTab, depending on the subscription. Add stays off until Yump accepts the subscription ID.

What the dialog shows next depends on the type:

Get Tasks for a location

Action streams and checklist streams need Tasks at the location. Without it, the stream picker says "To create this, first add Tasks."

Tasks is an add-on. Contact Yump to add it. When you have the subscription ID from Yump, add Tasks to the location in Admin > Touchpoints, as above.

Delete a touchpoint

  • In Admin: the delete is saved at once. You are asked first. For most touchpoints the message says "All its results are deleted too. This can't be undone." For Tasks it says "All its tasks are deleted too. This can't be undone."
  • In the location settings: the delete waits until you click Save. Cancel undoes it.

Set up the device or channel

Did this help?